Selecting A Dab+ Station; Saving Stations In Station Memory - Kenwood M-819DAB Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Starting the automatic station search again
• Press the
button to retrieve the DAB menu.
MENU
"FULL SCAN" will show on the display. Start the search with the
• During the search the display will show the number of stations found so far.
• If no stations are found during the search, then "NO DAB" will be displayed for approx
and then change to the display "FULL SCAN".
Please then check that the antenna is connected correctly or try to find a different position- for the
device to achieve a better reception.
Manual tuning of ensembles
• Press the
MENU
button to retrieve the DAB menu.
• Press the
button until "MANUAL" shows in the display.
TUN+
• Using the
button, the function is confirmed and the display will show the station which is
Enter
currently set with the corresponding frequency.
• Press the
or
TUN+
• Confirm selection using the
another press of the button will load the current ensemble.

Selecting a DAB+ station

The stations saved alphabetically in the stations list can be retrieved as follows:
• Press the
or
TUN+
stations list.
• When you have selected the desired station, press the
wait 2 seconds for the playback to start. "LOADING" appears in the display.
• If the reception level for the selected station is not sufficient for trouble-free playback,
then"OFF AIR"will appear in the display. Please then select a different station.

Saving stations in station memory

There are 20 memory spaces available to make it easier to find DAB stations. To assign the memory,
proceed as follows:
• Select a station to be saved
• Press the
button until the display flashes and shows a memory space. An empty memory
PRG
space is indicated by "EMPTY", an assigned space is shown with its frequency. You can also
re-assign a memory space which is already in use.
• Press the
or
TUN+
• Confirm save using the
• The stations can now be selected with the
buttons to manually select another channel.
TUN-
button. Then the signal level will be shown in the display,
Enter
buttons on the remote control to scroll backwards or forwards in the
TUN-
buttons to select a memory space.
TUN-
button. "STORED"flashes briefly on the display.
Enter
button on the remote control or
Enter
or
buttons.
button.
Enter
.
2 seconds
13

Publicité

Table des Matières
loading

Table des Matières