Kibernetik Nanyo 35AA Mode D'emploi page 33

E | DRAINAGE
During the process of cooling, some water will be extracted from the air into the unit. If the
tank is full, both of the compressor and motor will stop. The "water full" sign will light on,
also the machine will beep as reminder.
To make the cooling work again, please empty the water by one of the following ways:
Fig. 20
1. Turn off the air conditioner and avoid moving it when full.
2. Position a container (a water tray for example) underneath the drain hole.
3. Remove the drain knob & rubber plug from the drain hole and allow the water to drain
out.
4. When the container is almost full, replace the rubber plug in the drain hole and empty
the water tray.
5. Repeat until the unit is emptied.
6. Replace the rubber plug and tighten the drain knob firmly.
7. Switch on the unit - the full water or compressor operating indicator should not be
flashing.
If you wish to operate the unit without the need to empty the water tank, please:
Fig. 21
Remove the drain knob and rubber plug and retain for future use.
Connect the drain tube supplied to the water outlet as shown and locate the other end
into a drain.
Fig. 22
The drain tube may be extended by adding an extension tube and using a suitable
connector.
Please note (Fig. 23)
1. The drain must be at or below the outlet level.
Flashing comp / 'full water' indicator will not function in this mode of drainage.
2.
3. If you want to extend the water tube, you can connect it with another tube
(OD: 18mm)
OPERATING MANUAL | Air Conditioner Nanyo 35AA
33