Kibernetik Nanyo 35AA Mode D'emploi page 29

2. Using the adaptor (Fig. 9, 10)
Cut a 152mm diameter hole in the wall or window.
Feed exhaust hose through the window or wall and attach the threaded adaptor
from the outside as shown.
When not in use, plug the hole with the cover provided.
Mounting of the exhaust pipe (Fig. 11 - 14)
Use only the hose provided and clip exhaust hose and unit adaptor to the back of the
air conditioner
Avoid kinks and bends in the exhaust hose as this will cause expelled moist air to
build up causing the unit to overheat and shut down. Fig 11 & 12 show correct
position
The hose may be extended from 300 mm to 1'500 mm but for maximum efficiency
use the shortest length possible.
Warning!
The length of the exhaust pipe is specially designed according to the specification of this
product. Do not replace or prolong it with your own private hose as this could cause the
unit to mal-function.
Installation of the carbon filter (Fig. 15 - 16)
1. Remove the filter frame from the unit.
2. Separate the filter fixer from the filter frame.
3. Remove the active carbon filter from its plastic bag.
4. Insert the active carbon filter into the filter frame.
5. Fix the filter by reassembling the fixer onto the filter frame.
6. Re-fit the filter frame inside the unit.
OPERATING MANUAL | Air Conditioner Nanyo 35AA
29