Log Placement; Log Placement For Gdi3 / Gdi3E - Napoleon Oakville Serie Manuel D'installation

fi nishing
EN
3.3

log placement

3.3.1 log placement for GDI3 / GDI3E

WARNING
!
• Failure to position the logs in accordance with these diagrams or failure to use only logs specifi cally approved
with this appliance may result in property damage or personal injury.
• Logs must be placed in their exact location in the appliance. Do not modify the proper log positions, since
appliance may not function properly and delayed ignition may occur.
• The logs are fragile and should be handled with care.
PHAZER™ log and glowing embers, exclusive to Wolf Steel Ltd., provide a unique and realistic glowing effect that
is different in every installation. Take the time to carefully position the glowing embers for a maximum glowing ef-
"PHAZER™ logs [and glowing embers], exclusive to Napoleon/Continental, provide a unique and realistic
fect. Log colours may vary. During the initial use of the appliance, the colours will become more uniform as colour
glowing effect that is different in every installation. Take the time to carefully position the glowing embers for a
pigments burn in during the heat-activated curing process.
maximum glowing effect. Log colours may vary. During the initial use of the appliance, the colours will become
more uniform as colour pigments burn in during the heat-activated curing process."
Insert only if
applicable ---->
Studs
(Log #3)
IF APPLICABLE, INSERT DRAWING OF BURNER/SUPPORT WITH APPROPRIATE LA-
IF NOT APPLICABLE, HIDE THIS SECTION AND USE BOXES BELOW.
Lower Media Tray
(Logs #6, #7, and #8)
16
W415-1802 / E / 01.20.20
If applicable, insert the following statement:
note:
Log numbers are located on the bottom or back of the logs.
note:
Log numbers are located on the bottom or back of the logs.
Burner Ports
BELS (I.E. STUDS, PILOT SHIELD, BURNER PORTS, ETC.).
A2
A1
Burner Overview
Pilot Shield
Studs
(Log #2)
B1 B2