Jennair W10918236C Guide D'utilisation Et D'entretien page 29

PERFORMANCE DATA SHEET (CONTD.)
Contaminant Reduction
Carbamazepine
Phenytoin
Naproxen
Bisphenol A
Test Parameters: pH = 7.5 ± 0.5 unless otherwise noted. Flow = 0.6 gpm (2.27 Lpm). Pressure = 60 psig (413.7 kPa). Temp. = 68°F to 71.6°F (20°C to 22°C).
Rated service capacity = 200 gallons (757 liters).
The compounds certified under NSF 401 have been deemed as "emerging compounds/incidental contaminants." Emerging compounds/incidental contaminants
are those compounds that have been detected in drinking water supplies at trace levels. While occurring at only trace levels, these compounds can affect the public
acceptance/perception of drinking water quality.
It is essential that operational, maintenance, and filter replacement
Q
requirements be carried out for the product to perform as advertised. Property
damage can occur if all instructions are not followed.
The disposable cartridge must be changed at least every 6 months.
Q
Use replacement filter P9RFWB2L, part #EDR2RXD1/EDR2RXD1B. 2015
Q
suggested retail price of $49.99 U.S.A./$49.99 Canada. Prices are subject to
change without notice.
The filter monitor system measures the amount of water that passes through
Q
the filter and alerts you when it is time to replace the filter.
Refer to the "Using the Controls" or "Water Filtration System" section (in the
Q
User Instructions or User Guide) to learn how to check the water filter status.
After changing the water filter, flush the water system. See "Water and Ice
Q
Dispensers" or "Water Dispenser" in the User Instructions or User Guide.
These contaminants are not necessarily in your water supply. While testing was
Q
performed under standard laboratory conditions, actual performance may vary.
The product is for cold water use only.
Q
The water system must be installed in compliance with state and local laws and
Q
regulations.
*Class I particle size: >0.5 to <1 um
Based on the use of Cryptosporidium parvum oocysts
†
Fibers greater than 10 um in length
††
NSF is a registered trademark of NSF International.
®
Influent Challenge
Concentration
1400 ± 20%
200 ± 20%
140 ± 20%
2000 ± 20%
Maximum Permissible Product
Water Concentration
200 ng/L
30 ng/L
20 ng/L
300 ng/L
Do not use with water that is microbiologically unsafe or of unknown quality
Q
without adequate disinfection before or after the system. Systems certified for
cyst reduction may be used on disinfected waters that may contain filterable
cysts. EPA Est. No. 082047-TWN-001
Refer to the "Warranty" section for the Manufacturer's limited warranty, name
Q
and telephone number.
Application Guidelines/Water Supply Parameters
Water Supply
Water Pressure
Water Temperature
Service Flow Rate
Your water filtration system will withstand up to 120 pounds per square inch (psi)
Q
water pressure. If your water supply is higher than 80 psi, install a pressure
reducing valve before installing the water filtration system.
Average%
Reduction
>97.9%
93.8%
96.1%
>99.2%
Potable City or Well
30 psi -120 psi (207 - 827 kPa)
33° - 100°F (0.6° - 37.8°C)
0.6 GPM (2.27 L/min.) @ 60 psi. (413.7 kPa)
ASSISTANCE | 29