Checking The Bevel; Cleaning The Pump - Lackmond BEAST 10 Guide D'utilisation

CHECKING THE BEVEL

1. Position the worktable (9) so that it is under
the blade.
2. Loosen the blade cover lock knob.
3. Swing the blade cover (6) open.
4. With the bevel indicator at 0 degrees, use a framing
square to ensure the blade is square with the table.
5. If the blade is not square to the sliding table, adjust
the positive stop screw (A) in the direction that the
blade needs to move in order to square it to the
table. Use a small square to check blade to table
squareness.
6. Repeat steps 4 and 5 with the bevel indicator set 45
degrees and using the 45 degree positive stop
7. To adjust pointer (B) to align to 0° or 45° mark on
scale loosen screw on pointer and adjust to align to
correct mark and re-tighten screw.
8. Close the blade cover and relock

CLEANING THE PUMP

Remove the front plate and the impeller, and use a
small brush or stream of water to clean up any debris.
The pump shaft cannot be removed.
If the water from the pump is reduced
or has stopped, replace the pump or
have it repaired by the qualified personnel.
Some dust created by power sanding,
sawing, grinding, drilling, and other
construction activities contains chemicals known [to
the State California] to cause cancer, birth defects or
other reproductive harm.
Some examples of these chemicals are:
• Lead from lead-based paints.
• Crystalline silica from bricks and cement and other
masonry products.
• Arsenic and chromium from chemically treated
lumber.
Your risk from these exposures varies, depending on
how often you do this type of work. To reduce your
exposure to these chemicals: work in a well ventilated
area, and work with approved safety equipment, such
as those dust masks that are specially designed to filter
out microscopic particles.
MAINTENANCE
17 17
(continued)
REMOVING THE WATER
NOZZLE
It may be necessary to remove or replace the nozzle. If
so use perform the following steps:
1. Use the on-board Allen wrench (5c) to loosen the cap
screw (C).
2. Flip the retaining arm (D) up and release the nozzle
and hose assembly.
3. Grasp the hose and pull the nozzle firmly to
disconnect the nozzle from the hose.
D
C
B
A
FIGURE 28
FIGURE 29