Bevel Cut; Plunge Cut; Adjusting Depth Of Cut - Lackmond BEAST 10 Guide D'utilisation

Bevel Cut

The saw enables you to make beveled cuts at
45-degrees and 22.5 degrees.
CAUTION: If using the bevel function, the saw must be
positioned exactly at 45 or 22.5 degrees as shown on
the bevel indicator. Make sure the pointer matches up
with the line on the bevel scale.
To make a bevel cut:
1. Loosen the bevel lock (A).
2. Tilt the saw head so that the pointer on the saw
head aligns with the desired bevel as shown on the
bevel indicator (B).
3. Tighten the bevel lock.
4. Position and press the tile firmly with two hands
during cutting.
5. Move the table forward with two hands during
cutting while holding tile securely against table
backstop.
6. Do not force the work piece or move the table too
quickly.

Plunge Cut

1. Loosen the depth of cut lock knob (18).
2. Raise the cutting head to the full, upright position.
3. Align the tile under the cutting wheel by moving the
table to the desired position.
4. While holding the table securely in place, plunge the
saw into the material. Do not force the saw or move
the saw too quickly into the material.

ADJUSTING DEPTH OF CUT

You can adjust the depth of cut to accommodate
materials of varying thickness, up to 3-1/4" inches.
1. Loosen the plastic wing lock nut (E) by turning
counter clockwise.
2. Turn Depth of Cut Lock Knob (18) counter clockwise
to loosen and raise cutter head up to higher
position.
3. Adjust Height adjustment knob (17) to desired depth,
lowering cutter head to verify depth as needed.
4. Tighten plastic wing lock nut (E) to lock Height
Adjustment knob (17) in place.
5. Lower cutter head until cutter head stops and lock
depth of cut knob (18) in place to secure cutter head
for through cuts or leave knob (18) loose for plunge
cuts.
You can set the plunge depth to make repeated plunge
cuts of the same depth in multiple workpieces.
If you are going to make repeated
plunge cuts at the same cutting depth,
leave the depth of cut lock knob loose. Otherwise,
always re-tighten the depth of cut lock knob.
OPERATION
15 15
(continued)
FIGURE 23
18
FIGURE 24
17
18
FIGURE 25
B
A
E