Changing The Saw Blade; Maintenance - Lackmond BEAST 10 Guide D'utilisation

For your safety, turn off the switch and unplug saw from the power source before performing any
maintenance or cleaning. If the power cord becomes damaged in anyway, replace it immediately
with the approved cord. When cleaning the saw, do not expose the motor to direct water. If excessive water is
introduced into the motor, electric shock and/or damage to the motor can occur.
Do not service the electric motor's internal components yourself. Contact an authorized service center.
Never use water or any other chemical liquids to clean the electrical parts of the machine.
Use a soft cloth to clean off the water and dust from the machine.
Keep the ventilation slots of the motor clean to prevent overheating.
Periodic maintenance of your tile saw allows for long life and trouble-free operation. The cutting residue that the
saw generates could be considerable. A cleaning, lubrication, and maintenance schedule should be maintained.
As a common sense and preventative maintenance practice after each use, follow these recommended steps:
Clean the entire saw with fresh water after each use.
Pump clean/fresh water for 1 minute through the water pump and blade guard assembly to
safeguard against slurry build-up and clogging.
Make sure the guide rails are lubricated.
If the table is not sliding easily, lubricate the bar lightly.
Inspect the diamond cutting wheel for its overall integrity. Check the rim for wear or damage
and replace cutting wheel if necessary.

CHANGING THE SAW BLADE

1. Loosen the blade cover lock knob (A, Fig. 27).
2. Swing the blade cover (6) open
3. Locate the supplied blade wrench on the saw arm
assembly.
4. Depress the blade spindle lock (B, Fig. 26) and use
the blade wrench (C, Fig. 27) to loosen the arbor
lock nut (D, Fig. 27)
5. Remove the arbor lock nut.
6. Remove the blade.
7. Place the new blade on the arbor so that the arrow
on the blade is pointing in the same direction as the
arrow on the blade cover. (See Figure 27)
8. Replace the arbor nut and tighten while depressing
the spindle lock.
9. Close the cover and tighten the cover lock knob.

MAINTENANCE

16 16
B
FIGURE 26
C
D
FIGURE 27
A