Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Prior to tool assembly and use, read
this manual thoroughly to familiarize
yourself with proper assembly, maintenance and safety
procedures.
Check shipping carton and machine for damage
before unpacking. Carefully remove components in
top foam layer. Remove the top layer of foam then
remove all components in the bottom layer of foam.
Lay out all parts on a piece of cardboard or other
clean, flat surface. Always check for and remove
protective shipping materials around motors and
moving parts. Do not discard shipping carton and
packing materials until you have carefully inspected the
contents, assembled the machine and are satisfied that
it operates correctly.
SHIPPING CONTENTS
Description (QTY)
1.
Main frame
2.
Lower splash tray (1)
3.
Upper splash tray (1)
5.
Motor/Arm Assembly (1)
5b.
Hose
5c.
Blade wrench (1) & Allen wrench (1)
9.
Worktable (1)
1
1
5c
5
UNPACKING
10.
11.
12.
14.
H1.
H2.
2
5b
Compare package contents to Component Parts List
and Hardware Package List prior to assembly to make
sure all items are present. Carefully inspect parts to
make sure no damage occurred during shipping. If any
parts are missing, damaged or preassembled, do not
assemble. Instead, call Service Center at 1-800-850-2044
for assistance.
After assembly remove any protective materials and
coatings from all of the parts and the tile saw. The
protective coatings can be removed by spraying
WD-40® on them and wiping them off with a soft cloth.
This may need to be redone several times before all of
the protective coatings are removed completely.
Miter guide (1)
Water Tray (1)
Table extension (1)
Pump
M10 X 60 Hex Head Screws (4)
8mm Allen wrench (1)
3
9
11
10
10
8
8
H1
H2
12
14
Publicité
Table des Matières
