Attach The Saw Arm Assembly; Assembly - Lackmond BEAST 7 Manuel D'instructions

The part and hardware names and numbers correspond to those used in Saw Features on page 7
and the Shipping Contents on page 8 & 9.
INSERT THE WATER TRAY
Ensure the saw is on a level
and stable surface that will
support weight of saw, tray and contents.
(See Figure 5) Insert water tray (1) by
sliding it into the frame as shown. The lip
of the tray should rest on top of the left
and right rails of the main frame.
If using with a stationary or portable stand
The Beast 7 can also be used with a
stationary or portable stand which can be
purchased separately. For instructions on
properly mounting and securing this tool
to a stand, refer to the owner's manual
shipped with your stand.
If you are using this tool
with a stationary or portable
stand, sold separately, make sure stand
assembly is on a level and stable surface
that will support weight of saw, tray and
contents
ATTACH THE SAW
ARM ASSEMBLY
1. Position the saw arm assembly (5) so that
the two pins (C, Fig. 6) on the mounting
plate align with the two middle holes in
the main frame (2)
2. Insert the pins into holes.
3. (See Figure 7) Secure the saw arm
assembly to the main frame using the
three M10 X 60 hex head screws (H1)
from the inside of the main frame.
Tighten using the supplied 8mm Allen
wrench (H2).

ASSEMBLY

1
C
H1
9
9
(continued)
FIGURE 5
FIGURE 6
FIGURE 7