Attach The Miter Guide - Lackmond BEAST 7 Manuel D'instructions

ATTACH WORKTABLE
1. Position the slotted table lock (A, Fig. 8)
in the open position so that the groove is
parallel to the rails on the main frame.
2. Position the worktable (9) so that the two
left bearings (B, Fig. 8) on the bottom
engage, one over and one under, with the
left rail of the main frame. The wheel on
the right side of the work table should ride
along the top of the right rail on the main
frame.
3. Slowly slide the table onto the rails,
pushing it all the way in.
4. Pull up on the table stop (C, Fig. 9) and
rotate it 90 degrees until it clicks into
place. This will prevent the table from
sliding backward, off the main frame.
5. To lock table in place, so it will not move,
engage table lock (C, Fig. 9) into rail at
location shown.

ATTACH THE MITER GUIDE

1. Attach the miter guide (3) by engaging the
groove (C) on the underside of the miter
with the front rail.
2. Tighten in place using the miter lock
knob (D).
ASSEMBLY
B
C
10
(continued)
FIGURE 8
C
FIGURE 9
FIGURE 10
A
D