Attach The Miter Guide - Lackmond BEAST7 Guide D'utilisation

ATTACH WORKTABLE
1. Position the left side of the worktable (4)
so that the large grooved wheel (A, Fig. 8)
is engaged with the top of the rail and the
smaller bottom wheel (B, Fig. 8) engaged
with the underside of the rail.
2. Move the table forward until the wheels
on the left side are also engaged with the
left rail.
3. Guide the worktable forward until the
wheel on the right (C, Fig. 9) and the
positive lock stop (D, Fig. 9) align with the
slots (E, Fig. 9) in the rail.
4. Pull the positive stop out and drop the
table into place. Ensure it moves freely.
NOTE: There are holes on the side of the
worktable. These allow for the addition
of an optional extension table that can be
purchased and installed separately.

ATTACH THE MITER GUIDE

1. Attach the miter guide (3) by engaging the
groove (C) on the underside of the miter
with the front rail.
2. Tighten in place using the miter lock
knob (D).
ASSEMBLY
C
10
10
(continued)
A
FIGURE 8
E
D
FIGURE 9
FIGURE 10
B
C