Before First Use - Klarfit VIBE 3DX PRO Guide Rapide

EN
26

BEFORE FIRST USE

Step 1: Location
Select a suitable location for the vibration plate. Leave at least 1 meter of
clearance on both sides of the machine to prevent injury. Place the machine on
a stable, level surface with a suitable cover for your fl oor or carpet. Insert
2 AAA batteries into the remote control.
Step 2: Transport
Transport wheels are located on the underside of the right edge of the
machine. Use the castors to move the unit to your preferred location.
Step 3: Resistance ands
Use the snap hooks to attach the resistance bands to the metal brackets on the
unit. These are located under the control panel at the front of the unit.
CAUTION
Risk of injury! Make sure that the snap hook lock is tightened
so that the holder does not come loose during use!
Step 4: Adjusting the resistance bands
Shorten: take Part A in one hand and start to thread
through the band from underneath. This should
create a small loop at point B. Pull point D away from
Part A (whilst keeping hold of Part A) so that the loop
disappears.
Lengthen: thread a small amount of band through
Part A as before to create a loop at point B. Then
pull the band at point C so that the handle moves
towards Part A. This should increase the loop and
now you will need to thread the loop through Part A
so it disappears.
Note: When not in use, please ensure resistance bands are stored away
safely so they are no potential trip hazard.