Set-Up; Controls - Honda HRS536C4SKEA Manuel De L'utilisateur

SET-UP

UNPACKING
Remove all the cardboard from around the handlebar.
HANDLEBAR SETUP
1. Loosen the two knobs
[1] on the lower
handlebar enough to
raise the handlebar into
the mowing position.
Pull the flywheel lever
back and raise the
handlebar.
2. Release the flywheel
brake lever and tighten
the knobs securely.
3. Connect the spark plug cap.
ENGINE OIL
The mower is shipped WITHOUT OIL in the engine.
Add enough SAE 10W-30 API
service category SJ or later oil
to bring the oil level between
the upper limit [2] and lower
limit [3] marks on the dipstick
[1] as shown.
Do not overfill the engine
with oil. If the engine is
overfilled, the excess oil may
get transferred to the air
cleaner housing and air filter.
FUEL
Refer to page 6.
BEFORE USING YOUR
LAWNMOWER
Before using the lawnmower,
all mower operators must read the following chapters:
• SAFETY INSTRUCTIONS (page 2)
• CONTROLS (page 4)
• PRE-OPERATION CHECKS (page 5)
• OPERATION (page 7)
• MAINTENANCE SCHEDULE (page 10)
4

CONTROLS

FUEL VALVE
The fuel valve [1] opens and closes the connection between the fuel
tank and the carburetor.
[1](2)
CUTTING-MEANS CONTROL
The cutting-means control [1] is
connected to the engine
flywheel brake and the ignition
switch. The engine will not start
unless this lever is pulled
backwards.
DRIVE CLUTCH CONTROL
The drive clutch control [2]
engages and disengages the
transmission that drives the rear
wheels. The drive clutch control
should only be engaged after the
engine has been started.
CUTTING HEIGHT
ADJUSTMENT LEVERS
[1]
There are six adjustment
settings. The cutting height
figures are approximate. The actual height of cut grass will vary with
[2]
lawn and soil conditions.
[3]
ENGLISH
26 mm
37 mm
51 mm
63 mm
76 mm
88 mm
REAR
OFF
ON
[1]
[1]
[2]
FRONT