Philips PT927 Mode D'emploi page 7

Masquer les pouces Voir aussi pour PT927:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 108
-
.Children should be supervised to ensure that they do not play with
the shaver and the Jet Clean System.
-
Always unplug the shaver before you clean it under the tap.
Caution
-
Never immerse the shaver in water.
-
Never immerse the Jet Clean System or the charging stand in water
nor rinse it under the tap.
-
Do not use the shaver in the bath or in the shower.
-
Never use water hotter than 80°C to rinse the shaver.
Be careful with hot water. Always check if the water is not too hot, to
-
prevent your hands from getting burnt.
The shaver, the Jet Clean System, the charging stand and the other
-
accessories are not dishwasher-proof.
-
Water may leak from the socket at the bottom of the shaver when you
rinse it. This is normal and not dangerous because all electronics are
enclosed in a sealed power unit inside the shaver.
Do not use the shaver, Jet Clean System, adapter, charging stand or any
-
other part if it is damaged, as this may cause injury. Always replace a
damaged adapter, charging stand or part with one of the original type.
Use, charge and store the shaver and the Jet Clean System at a
-
temperature between 10°C and 35°C.
-
Always place and use the shaver and the Jet Clean System on a surface
that is luid-resistant.
Only use the adapter, charging stand and accessories supplied.
-
-
Always put the protection cap on the shaver to prevent damage and to
avoid dirt accumulation in the shaving heads.
-
Only use the Jet Clean System with the original Jet Clean solution
(HQ200).
Always place the Jet Clean System on a stable, level and horizontal
-
surface to prevent leakage.
When the Jet Clean System is ready for use, do not move it to prevent
-
leakage.
-
The Jet Clean System thoroughly cleans but does not disinfect your
shaver, therefore do not share the shaver with others.
-
Empty the cleaning chamber of the Jet Clean System and clean the
cleaning chamber thoroughly by rinsing it with hot tap water every
15 days.
-
If the shaver and the Jet Clean System are subjected to a major
change in temperature, pressure or humidity, let them acclimatise for
30 minutes before you use them.
English
7

Publicité

Table des Matières
loading

Table des Matières