Resetting The System; About Sound Retriever; About Ipod/Iphone - Pioneer XW-NAC3-K Mode D'emploi

Additional information
Problem
The Bluetooth wireless
technology device cannot be
connected or operated. Sound
from the Bluetooth wireless
technology device is not emitted
or the sound is interrupted.
*
The line-of-sight transmission distance is an estimate. Actual transmission distances supported may differ depending on
surrounding conditions.

Resetting the system

Use this procedure to reset all system settings
to the factory default.
• When performing reset, first disconnect all
components connected to this unit.
1 Switch the unit on.
2 Press and hold INPUT SELECTOR on the
top panel, and then press and hold
STANDBY/ON
for three seconds.
Power is set to standby mode.
The next time you switch on, all the system
settings
should be reset.

About Sound Retriever

The "Sound Retriever" function utilized in this
unit has been uniquely developed by Pioneer.
This function enhances sound data lost during
compression of MP3 and other file types,
allowing the user to enjoy sound quality closer
to that of the original signal data. In the case of
Bluetooth AUDIO, the "Sound Retriever Air"
function is used to enhance data lost by
compression during Bluetooth transmission.
Remedy
• Check that no object that emits electromagnetic waves in the 2.4 GHz
band (microwave oven, wireless LAN device or Bluetooth wireless
technology apparatus) is near the unit. If such an object is near the unit,
set the unit far from it. Or, stop using the object emitting the
electromagnetic waves.
• Check that the Bluetooth wireless technology device is not too far from
the unit and that obstructions are not set between the Bluetooth wireless
technology device and the unit. Set the Bluetooth wireless technology
device and the unit so that the distance between them is less than about
10 m* and no obstructions exist between them.
• The Bluetooth wireless technology device may not be set to the
communication mode supporting the Bluetooth wireless technology.
Check the setting of the Bluetooth wireless technology device.
• Check that pairing is correct. The pairing setting was deleted from this
unit or the Bluetooth wireless technology device. Reset the pairing.
• Check that the profile is correct. Use a Bluetooth wireless technology
device that supports A2DP profile and AVRCP profile.

About iPod/iPhone

"Made for iPod" means that an electronic
accessory has been designed to connect

specifically to iPod and has been certified by
the developer to meet Apple performance
standards.
"Works with iPhone" means that an electronic
accessory has been designed to connect
specifically to iPhone and has been certified by
the developer to meet Apple performance
standards.
Apple is not responsible for the operation of
this device or its compliance with safety and
regulatory standards.
iPod is a trademark of Apple Inc., registered in
the U.S. and other countries. iPhone is a
trademark of Apple Inc.
09
41
En