Shuffle; Hi-Lite Scan - Pioneer XW-NAC3-K Mode D'emploi

03 iPod/iPhone playback
2

SHUFFLE

Two iPod/iPhone units can be played
alternately with no break in sound (SHUFFLE
A bit before the currently playing iPod/iPhone
track ends, playback begins on the other iPod/
iPhone track and the volume is gradually
raised to fade in seamlessly (Cross fade).
During the SHUFFLE
track playback is set by the shuffle function.
1 Connect two iPod/iPhone units to the
iPod/iPhone connector ports (iPod a, iPod b),
then press iPod a or iPod b.
2 Press MENU to access the iPod/iPhone
menu.
3 Select the track area that you want to
play back, then press ENTER.
4 Press .
The SHUFFLE mode is set, and the SHUFFLE
2
indicator lights; the unit connected to the iPod
a connector port will playback.
A bit before the currently playing iPod/iPhone
track ends, the other iPod/iPhone unit begins
cross fade playback. The same operation is
repeated thereafter until all tracks on both
units have been played.
• To cancel the SHUFFLE
once again, or .
• The SHUFFLE
if the function is switched to any another
input (including iPod a or iPod b).
Note
1 During Cross Fade operation, /, and / are deactivated.
'
2 If a track s total length is too short, the track will be played back from the track beginning for a few seconds.
14
En
operation, the order of
2
1
mode, press either
2
mode will also be canceled
2

HI-LITE Scan

Each track is played back for a few seconds at
a certain time from the track beginning, thus
).
2
allowing desired tracks to be found quickly.
1 Connect an iPod/iPhone to the iPod/
iPhone connector ports, then press iPod a or
iPod b.
2 Press MENU to access the iPod/iPhone
menu.
3 Select the track area that you want to
play back, then press ENTER.
4 Press HI-LITE.
HI-LITE scan function will begin from the first
track on the selected iPod/iPhone.
If playback was already underway, the HI-LITE
scan will begin from the currently playing
track.
After a track is played for a few seconds, the
2
next track will be found and a certain time
from the track beginning will be played for a
few seconds.
When two iPod/iPhone units are connected
simultaneously, the first track on the alternate
iPod/iPhone will be found and a certain time
from the track beginning will be played for a
few seconds.
Thereafter, the same process will be repeated
until all tracks have been found and played for
a few seconds each.
• To cancel the HI-LITE Scan operation,
press HI-LITE once more.
• The HI-LITE Scan mode will also be
canceled if the function is switched to any
another input (including iPod a or iPod b).
2