Pioneer XW-NAC3-K Mode D'emploi page 39

Additional information
Problem
Cannot access the network.
The audio files stored on
components on the network,
such as a PC, cannot be played
back.
Cannot access the component
connected to the network.
Audio playback is undesirably
stopped or disturbed.
Remedy
• The LAN cable is not firmly connected. Firmly connect the LAN cable (see
page 23).
• The router is not switched on. Switch on the router.
• The corresponding IP address is not properly set. Switch on the built-in
DHCP server function of your router, or set up the network manually
according to your network environment (see page 27).
• The IP address is being automatically configured. The automatic
configuration process takes time. Please wait.
• Internet security software is currently installed in the connected
component. There are cases where a component with Internet security
software installed cannot be accessed.
• Install Windows Media Player 11 or 12 on your PC (see page 30).
• Play back audio files recorded in MP3, WAV (LPCM only), MPEG-4 AAC,
FLAC, or WMA. Note that some audio files recorded in these formats may
not be played back on this unit.
• Audio files recorded in MPEG-4 AAC or FLAC are being played back on
Windows Media Player 11 or 12. Try using another server. Refer to the
operation manual supplied with your server.
• The component connected to the network is not properly operated. Check
whether the component is affected by special circumstances or is in the
sleep mode. Try rebooting the component if necessary.
• The component connected to the network does not permit file sharing. Try
changing the settings for the component connected to the network.
• The folder stored on the component connected to the network has been
deleted or damaged. Check the folder stored on the component
connected to the network.
• The component connected to the network is not properly set. If the client
is automatically authorized, you need to enter the corresponding
information again. Check whether the connection status is set to "Do not
authorize".
• There are no playable audio files on the component connected to the
network. Check the audio files stored on the component connected to the
network.
• The audio component on the network which has been switched off is
switched on. Switch on the audio component on the network before
switching on this unit.
• Check whether the audio file was recorded in a format supported by this
unit (see page 22).
• Check whether the folder has been damaged or corrupted.
• Note that there are cases where even the audio files listed as playable on
this receiver cannot be played back or displayed.
• There is heavy traffic on the network with the Internet being accessed on
the same network.
• When in the DMR mode, and depending on the external controller used,
playback may be interrupted when the controller is used to adjust the
sound volume. In this event, perform sound volume adjustments from the
main unit or the remote control unit (see page 20).
09
39
En