Setting The Pin Code; Pairing This Unit And Bluetooth Wireless Technology Device - Pioneer XW-NAC3-K Mode D'emploi

Bluetooth
® AUDIO for Wireless Enjoyment of Music

Setting the PIN code

Set this unit's PIN code to the same setting as
that for the Bluetooth wireless technology
device used. Supported PIN code setting
values include 0000, 1234 or 8888.
• Default setting: 0000
STANDBY/ON
a
TIMER
a
WAKE UP(GREEN)
SLEEP(ORANGE)
INPUT
SELECTOR
1 Press BT A.
When the Bluetooth wireless technology
device is not connected, 'Device
Disconnected' is displayed. If the Bluetooth
wireless technology device is connected,
disconnect it.
2 When 'Device Disconnected' is displayed,
press and hold VOLUME – on the top panel,
and then press and hold  STANDBY/ON for
three seconds.
The PIN code will be changed, and the newly
set PIN code will be displayed. Choose
between '0000', '1234' and '8888'.
Repeat step 2 until the PIN code is reset to the
value desired.
These settings are preserved in memory even
when the power is turned OFF. When resetting
the PIN code, turn the power ON, and perform
step 2 without any unit connected.
Note
1 • Pairing is required when you first use Bluetooth wireless technology device and this unit.
• To enable Bluetooth communication, pairing should be done with both of your system and Bluetooth wireless technology
device.
USB
b
VOLUME
Pairing this unit and Bluetooth
wireless technology device
"Pairing" must be done before you start
playback of Bluetooth wireless technology
content using Bluetooth AUDIO. Make sure to
perform pairing first time you operate the
system or any time pairing data is cleared.
"Pairing" is the step necessary to register
Bluetooth wireless technology device to enable
Bluetooth communications.
see also the operating instructions of your
Bluetooth wireless technology device.
1 Press BT A.
When the Bluetooth wireless technology
device is not connected, 'Device
Disconnected' is displayed. If the Bluetooth
wireless technology device is connected,
disconnect it.
2 When 'Device Disconnected' is displayed,
press .
'Pairing' will be displayed, and the unit will
enter the pairing standby mode.
Bluetooth
3 Switch on the
technology device that you want to perform
pairing with, place the device within 1 meter
of the system, and set it to the pairing mode.
Pairing begins.
4 Check to see that the
detected by the Bluetooth
technology device.
'Device Connected' is displayed when
Bluetooth wireless technology device is
connected. Then the connected device name is
displayed.
1
For more details,
wireless
Bluetooth
AUDIO is
wireless
04
17
En