Advanced Operations For Internet Radio; Saving Internet Radio Stations; Retrieving Saved Internet Radio Stations; Setting Up The Network - Pioneer XW-NAC3-K Mode D'emploi

Playback with HOME MEDIA GALLERY inputs
Advanced operations for
Internet radio

Saving Internet radio stations

This unit can remember the Internet radio
stations that you often listen to in three classes
(A to C) with up to ten stations in each class to
make the total of 30 stations at its maximum
capacity.
Before proceeding with the following steps,
check whether you have followed Steps 1 to 3
at Playback with Home Media Gallery on
page 23.
1 Tune into the Internet radio station.
Tune into the desired Internet radio station by
following Steps 1 to 3 at Playback with Home
Media Gallery on page 23.
2 Press T.EDIT to switch to the station
saving mode.
3 Press CLASS.
Select the desired class from A to C.
Use / to select the number, and then
4
press ENTER.
Select the desired number from 0 to 9.
Note
1 In case you make changes to the network configuration without the DHCP server function, make the corresponding changes
to the network settings of this unit. Before you set up the network, consult with your ISP or the network manager for the
required settings. It is advisory that you also refer to the operation manual supplied with your network component.
Retrieving saved Internet radio
stations
You need to save Internet radio stations first
before retrieving them. If there are no Internet
radio stations currently being saved, see
Saving Internet radio stations above and save at
least one Internet radio station before
proceeding with the following steps.
1 Press CLASS.
Each time you press CLASS, the class switches
to A to C in turn.
Use / to select the station number.
2
'No Preset' appears when you select an
Internet radio station currently not being
saved.

Setting up the network

In case the router connected to the LAN
terminal on this unit is a broadband router
(with the built-in DHCP server function), simply
turn on the DHCP server function, and you will
not need to set up the network manually. You
must set up the network as described below
only when you have connected this unit to a
server without the DHCP server function.
05
1
27
En