Care And Cleaning; Cleaning The Outside; Cleaning The Condenser - GE UCC15 Manuel D'utilisation Et Instructions D'installation

Care And Cleaning

Cleaning the Outside

The stainless steel door and door handle can be cleaned
with a commercially available stainless steel cleaner.
Soft Cleanser™ will remove surface rust, tarnish and
small blemishes.
Cleaning the Ice Storage Bin
making system has been cleaned and the bin is empty.

Cleaning the Condenser

The condenser has fins and tubes that can become
clogged with dirt and lint.
NOTE: Outdoor operation can lead to rapid buildup
of debris, such as leaves and other vegetation. The
condenser will need to be frequently checked for debris.
Clean it whenever the fins are obstructed.
Condenser surface
Winterizing
1. Clean the ice making system per the instructions
above.
2. Open the door. Push the ON/OFF button to turn the
ice machine off.
3. Turn off the water supply.
4. Drain the water reservoir by removing the rubber
stopper under the reservoir. It is located near the
back wall of the ice storage bin.
16
Rubber stopper
direction of the brush lines with a damp soft sponge. Do
not use appliance wax or polish on the stainless steel.
a clean cloth and wipe the interior of the ice storage bin
down the drain.
Allow to air dry.
To clean:
1. Remove the kickplate and front service panel.
2.
3.
NOTICE
Do not dent the fins.
4. Return the kickplate and front service panel to their
the original screws.
5. Disconnect the incoming water line at the inlet water
valve.
6. Open the door. Push the ON/OFF button to turn the
ice machine on.
7. Blow air through the inlet water valve. A tire pump can
be used.
8. Models with a drain pump installed should have about
into the ice storage bin drain.
NOTE:
9. Turn off and unplug the machine.
49-60745 Rev. 5