DePuy Synthes PUREVUE 242302 Mode D'emploi page 36

Icon/Setting Description
Pressing the Restore Factory Defaults Button erases modifications to
Restore
any of the Device, Video, Capture, Button, Media, Printer, Localization,
Factory
General, and OSD Settings and changes them back to what they were
Defaults
when the device was built .
A case will end automatically after a specified length of time when a Camera
Close Case Head is disconnected from the Camera Control System . You have the option
Timeout to specify the length of time before the case is automatically closed after the
Camera Head is disconnected .
Before a case begins, an animation prompt for connecting the Camera Head
to the Camera Control System runs on the display, an animation prompt
Equipment for connecting the Light Cable to the Camera Control System runs on the
Setup display, and an image prompt for White Balancing is shown on the display .
Workflow These equipment setup prompts are shown when the Equipment Setup
Workflow is enabled . The equipment setup prompts are not shown when the
Equipment Setup Workflow is disabled .
NOTE: Changes are saved automatically.
NOTE: The Custom Specialty Settings will not be restored to their factory defaults.
36