The Input/Output Ports - Radiation Alert Inspector + Manuel D'instructions

the end panel and the other end to the probe. Caution: If the probe is not
connected when turning the instrument on, the instrument will not function
properly and may cause damage. Do no remove the probe while the
instrument is on.
GM Detector
Window
Battery
Compartment
Figure 4 Inspector+ Rear View (Detector)

The Input/Output Ports

The Cal Input (Figure 1 (9)) port is used for calibrating electronically using a
pulse generator. For details, see "Calibrating Electronically" in Chapter 5.
The Output (Figure 1 (10) port below the Cal Input jack allows you to interface
the Inspector+ to a computer, data logger, or other device. For details, see
"Interfacing to an External Device" in Chapter 3.
The probe port on the end panel is for attaching the external probe. (present on
Inspector+ EXP only)
9