Interfacing To An External Device; Options; Wipetest Plate - Radiation Alert Inspector + Manuel D'instructions

5. To exit the Utility Menu at any time, press the SET button again. The
Inspector+ continues with the normal start-up routine. See options in the table
below:

Options

1. Auto Averaging or
3 sec. Averaging
2. Units Of
Measurements
3. Cal 100 Reset
4, 5, 6
7. Cal Factor Adjust
8. Factory Default
Reset
9. Revision #

Interfacing to an External Device

The lower output jack (Figure 1 (10)) on the left side of the Inspector+ is a dual
miniature jack that provides a data output that can be used to drive a CMOS or
TTL device. You can use it to record the counts on a computer, data logger, or
accumulating counter. The output at the tip of the plug provides a positive (5 volt)
pulse each time the Geiger tube detects a count. Visit seintl.com for more
information on Observer Software.
Options
W i pe Test Plate (patent # 5,936,246)
The stainless steel WipeTest Plate has a circular depression for placement of a
Function
"on" selects Auto Averaging
"oFF" selects 3 second
(fast response) averaging
Selects between mR/hr
and CPM or µSv and CPS
Automatically resets Cal
factor to 100
Reserved for future options
Manually adjusts cal factor
Automatically resets to
Auto Averaging, mR/hr, CPM,
and CAL 100
Displays software version number
Comments
Refer to
"Response Time
(Autoaveraging)" in
Chapter 3
Press the set Button
No toggling required
Use + or - Buttons
to increase or
decrease the value
Press the set Button
No toggling required
15