Whirlpool SDD 534 U Manuel D'instructions page 25

5.5 – DIGIT REGENERATION CYCLE (models with built-in water softener)
Attention: use exclusively specific salt for dishwashers and not kitchen salt!
The salt compartment takes approximately 1 kg of grain salt.
The salt compartment is located on the bottom of the tank. Take the basket out, unscrew the cap and pour salt in using
the funnel supplied with the machine. Before screwing the cap back on, remove any spilled salt near the opening. Top-
up with salt when there is no water in the tank so that the washing water cannot get into the water softener. Always
unplug the machine from the mains power supply before doing this operation. Remember to plug the machine back into
the mains socket after completing the operation.
When using the machine for the first time, after you fill with salt, add some water to the salt container.
5.6 – DRAIN
5.7 – DRAIN Digit versions
AUTOMATIC REGENERATION CYCLE
The regeneration cycle is automatic. The dishwasher is equipped with
a wash meter. When the set number of cycles is reached, the
dishwasher will activate the regeneration function the first time it is
switched off and the tank is emptied.
When the machine is working normally and the set number of cycles
is reached, the blinking icon
machine will activate the regeneration function the next time it is
switched off.
"NO SALT" LED (VERSIONS WITH SOFTENER):
Salt for dishwashers is fundamental for the regenerative cycle of the
softener installed in the machine. The blinking icon
that there is not enough salt in the container inside the tank. To top-
up, use the funnel supplied and clean any spilled salt from inside the
tank.
NB: REMOVE ANY
IMMEDIATELY, otherwise it could damage the surface of the tank
with rust or similar marks.
Models without drain pump:
Turn the machine off by pressing
overflow and wait for the tank to empty. Place the overflow back into the
tank and close the door. Deactivate the general wall switch.
Models with drain pump:
Open the door, remove the overflow pipe and close the door.
Turn the machine off by pressing the on/off
the emptying of the tank automatically. Drain pump will be activated until
the total drain of the tank and the wash cycle lamp will be on.
In order to reactivate the machine it is therefore necessary to place the
overflow back into the tank, close the door and press the on/off
button. Otherwise, if finished using the machine, deactivate the general
wall switch.
Total draining at the end of the day (models without drain pump)
Switch the machine off by pressing the on/off key
door and remove the overflow, wait until the machine is completely
emptied. Put the overflow back into its place and close the door
again.
Switch off the main wall switch and shut off the water inlet tap.
Total draining at the end of the day (models with drain pump)
Open the door, remove the overflow and close the door again.
Switch the machine off by pressing the on/off key
pump will start until the tank is completely empty. Before starting-up
the machine again, you need to put the overflow back into the tank,
appears. This points out that the
SPILLED SALT FROM
, open the door, remove the
in order to initiate
will point out
THE TANK
, open the
: the drain
25