Whirlpool SDD 534 U Manuel D'instructions page 24

During the cycle in course,
in progress, the program will stop. When the door is closed again, the program resets. In order to re-start the wash cycle, press the
cycle button again.
5.3 – MANUAL COLD RINSE AT THE END OF THE CYCLE (optional)
will light up blue and the cycle LED will start blinking. If the door is opened while the wash cycle is
CHOOSING AND STARTING A WASH PROGRAM
Use the button to select the wash program: one of the LEDs of
the selected cycles will light up:
P1: duration 60"
P2: duration 120"
P3: duration 180"
P4: duration 480"
Program P4 can be used to finish with the rinse cycle, by pressing the
START button again (blue) during the wash phase.
In order to start up the wash cycle, press
When the program is completed,
cycle LED stops blinking.
Unload the basket
On some models it is possible to set a cold rinse at the end of the
cycle.
Start the wash cycle by pressing
course keep the key pressed until
or .
from blue turns yellow and the
, and while the cycle is in
lights up.
24