Congratulations On Your New Automatic Door; Electronic Equipment Reception Interference; Environmental Requirements; Product Liability - DITEC DAB305 Instructions D'origine

Congratulations on your new automatic door!

Entrematic Group AB has developed automatic doors for more than 50 years. State-of-the-art tech-
nology and carefully tested materials and components provide you with a superior product.
As with all other technical products, your automatic door requires periodic maintenance and service.
It is essential that you know your automatic door (system) and that you recognize the importance
of maintaining it in compliance with applicable standards for safety.
Your local Entrematic Group-authorized representative is familiar with these standards, as well as
all applicable local codes and Entrematic Group recommendations for power-operated pedestrian
doors. Service and adjustments performed by your Entrematic Group-authorized representative,
will ensure safe and proper operation of your automatic door unit.

Electronic equipment reception interference

The equipment may generate and use radio frequency energy and if not installed and used properly,
it may cause interference to radio, television reception or other radio frequency type systems.
If other equipment does not fully comply with immunity requirements interference may occur.
There is no guarantee that interference will not occur in a particular installation. If this equipment
does cause interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
Re-orient the receiving antenna.
Relocate the receiver with respect to the equipment.
Move the receiver away from the equipment.
Plug the receiver into a different outlet so that equipment and receiver are on different branch
circuits.
Check that protective earth (PE) is connected.
If necessary, the user should consult the dealer or an experienced electronics technician for additional
suggestions.

Environmental requirements

Entrematic Group products are equipped with electronics and may also be equipped with batteries
containing materials which are hazardous to the environment. Disconnect power before removing
electronics and battery and make sure it is disposed of properly according to local regulations (how
and where) as was done with the packaging material.

Product liability

According to regulations, the following are the responsibility of the owner or caretaker of the
equipment
that the equipment operates correctly, so that it gives sufficient protection in regard to safety
and health
that the equipment is operated and regularly maintained, inspected and serviced by someone
with documented competence in the equipment and in applicable regulations
that the provided "Service Log Book" and "Site Acceptance Test and Risk Assessment" documents
are kept available for maintenance and service records
that inspection covers the emergency opening function (when applicable)
that the closing force is appropriate for the door size on fire-approved door systems (when ap-
plicable)
6 Issue 2020-04-02 1020517-DImulti-2.0