Philips Lumea Comfort Mode D'emploi page 24

EngliSh
24
2 About 1 second later, the yellow READY light
turns on. The device is now ready to deliver a
first pulse at the lowest intensity level.
3 If you wish to change the intensity level, press
the intensity button quickly and repeatedly
to increase the intensity level from 1 to 5
and from 5 directly back to 1, cyclically, until
you reach the desired level. The green level
lights indicate the level selected (see section
'Intensity level' below).
4 Place the skin contact surface on the skin.
Make sure that the skin is spread evenly and
smoothly and the skin contact surface is in
full contact with the skin. Make sure that the
yellow READY light starts blinking slowly.
5 Press the pulse button. The device first
determines the color of your skin. If the color
of the skin is light enough for safe treatment,
the device emits a pulse of light and produces
a soft popping sound at the same time. This
popping sound is normal for this device.
You may also feel a mild warm and tingling
sensation.
If you see no light pulse and the yellow READY
light blinks rapidly, this light is now the skin color
warning light that warns you that your skin color
is too dark for safe treatment. Try using the
device on a different body part. For assistance,
please visit www.philips.com/support or call
1-800-243-7884.
6 After emitting a pulse, Philips Lumea Comfort
recharges immediately for the next pulse.
Recharging takes a few seconds, depending
on the intensity level set. When recharging is
finished, the READY light turns on again.