Hemming; Sewing Blind Hems - Euro-Pro 473 Directives D'installation

(Model 377B only)
HE MMING
P re s s e r foot
P a tte rn s e le c tor
S titc h le ngth dia l
R ais e the foot and the needle to its highes t pos ition. R eplace the
foot with the hemmer foot.
F old over the fabric edge by about 3mm (1/8 inches ) and place it
under the foot. S ecure the folded edge with a few s titches . Take
out the workpiece and draw the hem into the hemmer foot by
pulling on the threads .
Lower the foot and s we the hem.
During s ewing, fold the fabric to the left a little and allow it to
run into the hemmer foot.
Make s ure that the fabric does not move under the right half of
the foot. T he fabric mus t be fed into the s croll of the hemmer
s ufficiently s o that the workpiece edge runs freely
groove under the foot.
S E WING B L IND HE MS
377B
Presser foot blind hem foot
B (
Pattern selector
1 to 3
S titch length dial
1. T urn up the hem to the des ired width and pres s . ( F ig. 1)
2. F old hem back agains t the right s ide of the garment with
top edge of hem extending about 4 mm (1/6 inches )
right s ide of the garment folded. (F ig. 2)
3. P lace the garment under the foot s o that double-folded edge
runs along the hemlguide and lower the foot.
S ew s lowly for better
zigzag s titches are s ewn on the hem edge and wide zigzag
s titches will jus t catch one thread of folded edge. (F ig. 3)
4. Unfold the fabric and you will have a bling
(F ig. 4)
he mme r foot
M ( )
1 to 4
(Model 473/377/374/373/372/372H)
374 473/373/372/372H
blind hem foot
) E ( )
1 to 3
control, making s ure the narrow
s titch hem
through the
to the
16
hemmer foot
3mm
( F ig. 1)
, ,
4mm ( 1/6 )
( F ig. 2)
G uide
a djus ting
( F ig. 1)
s c re w
G uide
F oide d e dge
( F ig. 3)
( F ig. 4)