Speed Control; For Main Cylinder; For Injection Rod - TECHCON SYSTEMS TS6500CIM Manuel D'utilisation

Figure 13.0 Manual Mode Screen
ACTIVATE
INJECTION
9.

SPEED CONTROL

9.1

For main cylinder

The main air cylinder drives cartridge kit up and down. The stroke speed of
the main air cylinder can be adjusted by rotating the flow control screw
(Fig. 14.0) counter clockwise to increase the speed and clockwise to
decrease the speed.
9.2

For injection rod

The injection rod air cylinder drives the injection rod up and down. The
injection speed can be adjusted by rotating the flow control screw (Fig.
14.0) counterclockwise to increase the speed and clockwise to decrease the
speed.
MAIN AIR CYLINDER
FLOW CONTROL
INJECTION ROD FLOW
CONTROL
MODE
ACTIVATE
MOTOR
Figure 14.0 Flow Control
17
PRESSURE
ACTIVATE
MIX CYCLE
SAFE TO RUN