Plastic Tray Installation; Spindle And Extension Installation - TECHCON SYSTEMS TS6500CIM Manuel D'utilisation

8.2

Plastic Tray Installation

The unit is shipped with a plastic tray to prevent any spilled material
migrating into the main control panel. Make sure to install the plastic tray
onto the base plate by aligning the four tabs into the base plate holes.
8.3 Spindle and Spindle Extension Installation
The unit is shipped with the spindle uninstalled. To install the spindle, align
it on the motor drive shaft then turn in clockwise direction.
Note: The spindle is designed to mix cartridge kits with 8'' (203mm) mix
rod. To mix cartridge kits with 6'' (152mm) mix rod, the spindle extension
needs to be installed. Follow the instructions below to install the spindle
extension:
SCREW
DRIVER
SPINDLE
ASSEMBLY
WRENCH
Figure 7.0. Remove Spindle Assembly
SPINDLE
ASSEMBLY
SPINDLE
EXTENSION
Figure 8.0. Spindle Assembly with Extension
12