WAGNER SuperFinish SF 27 Mode D'emploi page 5

Large volume container
If fitted, first remove the suction filter from
the suction system.
Insert the suction system of the Wagner device into the coupler.
With HC/PS:
Fit the enclosed 1.8 m-long return hose to the material return
on the Wagner device and suspend the other end of the hose
through the hose holder in the large container.
With SF:
Suspend the return hose of the suction system in an empty
container.
Fill the container with a maximum of 80 litres of the
coating material to be processed.
Open the ball cock.
Switch on your Wagner device as described in the respective
operating instructions.
Cleaning
The container is not resistant to scratches.
Do not use tools with sharp or pointed
edges for cleaning.
Pump any remaining coating material into the original container.
Uncouple the container connector and clean under running
water.
Rinse out empty container with water hose and clean with a brush.
Open and close ball cock several times with water running
through.
Bag support with pressing roller or sack mangle
(accessory)
Assembly
A) (Fig. 2)
1. Take off lid.
2. Place bag support (1) on container (2).
3. Fix bag support with the two splints (3).

1
2
Filling the reservoir
B)
1. Place bag on support such that the face end is facing the
opening.
2. Cut sack open.
3. Allow the coating material to flow into the receptacle.
Danger of crushing
Do not place hands under the roller.
Attention
4. Place pressing roller or sack mangle on rear end of bag and
roll forwards several times over the bag.
5. Strip remaining coating material from sack opening with
a spatula.
Accessories/Spare parts
Order Ref. Description
2309 957 Bag support with pressing roller
2323 178 Bag support with sack mangle
2309 959 Reservoir incl. lid
0097 321 B coupling
2312 302 Wheel and wheel cap
2312 301 Retaining splints for bag support
2310 653 Pressing roller
0348 963 Sack mangle
2383128 Container Connector (HC, PS 3.39)
2371930 Container Connector (SF 27/31)
0507964 Return hose
0342329 Cleaning brush
9100099 Coupling wrench
GB
3
1
2
5