Troubleshooting - Quick MILL 03000 Série Mode D'emploi

Istruzioni 03000-012 19-09-2007
Range 03000

11. TROUBLESHOOTING

Fault
Machine does not work (go on)
Little or no coffee dispensed
(mod. 03002 - mod. 03012)
Too much coffee is dispensed
(mod. 03002 – mod. 03012)
Coffee leaks from the dispensing unit
Cold coffee
Noisy pump
(mod. 03002 – mod. 03012)
QUICK MILL
9:30 Pagina 22
Fault type
Electrical
Electrical
Hydraulic
Hydraulic
Hydraulic
Hydraulic
Hydraulic
Hydraulic
Hydraulic
Hydraulic
Hydraulic
Hydraulic
Hydraulic
Hydraulic
Hydraulic
Hydraulic
Electrical
Hydraulic
Hydraulic
Hydraulic
Hydraulic
Solution
Plug in the machine.
Check the fuses.
Fill the water tank.
Descale the machine.
Replace the lime filter
Clean filters.
Put the steam wand inside.
Reduce the amount of coffee in the filter holder.
Too fine grind.
Increase the amount of coffee in the filter holder.
Too coarse grind.
Decrease the coffee quantity device.
Put the filter holder in its seat correctly.
Clean the edge of the filter holder.
Filter holder seal worn and needs to be replaced.
Reduce the amount of coffee in the filter holder.
Wait for the light to go out.
Put the filter holder in to warm it up.
Fill the water tank.
Replace the lime filter
Check the suction pipe to see if it is clogged.
GB
23