Filter Cartridge; Water Treatment - Outside Living Industries INFINITE spa CHAMPION Mode D'emploi

4
Maintenance
3. Then pull out the plastic stopper on the inside. The water can now flow out.
4. When there is no more water in the pool, press the BUBBLE button for 2–3 minutes to discharge the air from the air hose.
5. When the water has completely drained away, remove the filling hose and shut both outlets again.
CAUTION
The drained water can contain chemical residues and/or other unhygienic components, that can have a negative impact on health and the
environment. Check your local authority regulations to find out how you can safely and responsibly dispose of the waste water. To prevent the
growth of undesirable bacteria, make sure there is no more water in the pool.

4.2 Filter cartridge

Depending on use, the filter cartridge should be changed at least once a month.
Changing the filter cartridge
1. Make sure that the mains plug has been disconnected from the power supply.
2. Unscrew the filter cartridge by turning it anticlockwise.
3. Remove the filter cartridge cover.
4. Place the filter cartridge cover on the new filter cartridge and screw it in by turning it clockwise.

4.3 Water treatment

To ensure the comfort and safety of SPA users, the water parameters must be well-balanced. The mineral content of water is constantly chan-
ging and can be directly affected by persons in the water, water treatment products and by evaporation. Deviations from the desired values
can cause deposits that can damage the SPA.
As the volume of water is relatively small, it is difficult to maintain constant values.
It is therefore important to observe the following points:
- Start with water treatment immediately after filling the SPA. The power supply has to be ensured from this moment on, so that
filtration can be started immediately..
- Check the following water parameters and adjust them as follows:
- pH-value: 7.2 - 7.8
- Free chlorine: 3 –5 ppm
- Total alkalinity: 80 – 120 mg/l
- The stated values must be regularly checked, at least twice a week, and before each time the SPA is used.
- Use a good and clearly legible testing set for these tests.
- Use water treatment products to correct and adjust the values.
- If the SPA is being used regularly, the water must be completely changed at least every two months. If the SPA is used more intensively,
the water must be changed more frequently.
CAUTION
If the pH value and chlorine content are not corrected, it can have negative effects on the service life of components, which can invalidate the
warranty.
CAUTION
Never use fragrances. These oil-based products can result in deposits and leaks.
The use of fragrances will invalidate your warranty claim.
4.4 Water treatment products
Always add the water treatment to the middle of the SPA. The air jets and heater must be switched on to achieve an optimum treatment ef-
fect. The use of water treatment products in cold water has almost no effect. Keep the water treatment products in a cool, dry place inacces-
sible to children.
Test strips
Test strips are available which can be used to measure the pH value, chlorine content and alkalinity.
Chlorine granules/tablets
Increase the chlorine content After using chlorine granules or tablets, you must wait at least 7 hours before you can retest the water. The full
effects of the treatment can only be determined after this waiting period.
pH-plus
Increases the pH value.
pH-minus
Reduces the pH value.
Manual SPA 2/4/6 2019 3.indd 41 Manual SPA 2/4/6 2019 3.indd 41 19.11.19 11:55 19.11.19 11:55