Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
WARNING:
The machine is heavy. Remove the motor from the
machine before transporting. Get help loading the
machine and motor. Use proper lifting techniques.
Transporting the Machine - Using the Dolly Cart
CAUTION:
When deploying the dolly, the drum will contact the
floor or ground over which the machine is resting.
Care should be taken to avoid surfaces which might
damage or contaminate the drum.
CAUTION:
While transporting using the dolly, abrupt changes in
the direction of travel or the surface over which the
machine is being transported could cause the machine
to tip over. Also, the machine is more likely to tip over
when transporting across inclined surfaces.
Attaching and deploying the dolly:
1. Make sure the power cable is disconnected from the machine.
2. Attach the dolly to the rear of the machine by inserting the connection rod on the dolly into the two receiving clips on the back of the machine. (see Figure 2)
3. With the dolly attached to the machine as described above, tip the machine by lifting up on the operator's handle to raise the rear of the machine off the floor/
ground until the dolly swings under the machine. (See figure 3)
4. Using your foot, push the dolly into the retaining clips on the bottom of the machine.
5. Allow the machine to tip back and rest on the dolly wheels. (See figure 4)
Removing/Storing the dolly
The dolly can be stored on the machine in the "UP" position or it can be removed and stored separately.
1. Lift up on the operator's handle to tip the machine forward.
2. Pull the dolly out from under the machine. (See figure 5)
3. Rotate the dolly up toward the operator's handle. Push the dolly into the retaining clips on the back of the machine.
4. Lower the machine back to the floor.
5. To remove the dolly, push up on the two clips holding the connection rod and remove the dolly from the machine. (See figure 6)
Figure 2
Figure 5
Machine Transportation
Figure 3
Figure 6
8
AC Volt Meter
Circuit Breaker
Figure 1
Hour Meter
Handle Pigtail
C
Figure 4
Figure 7
Publicité
Chapitres
Table des Matières
Dépannage
