Ws Models; How To Operate Your Friedrich Room Air Conditioner; To Start Unit; To Set Mode Of Operation - Friedrich WallMaster WS08 Instructions D'installation Et D'utilisation

WS mod els
How to operate your Friedrich room air con di tion er
2
8
13
10 11 12

To start unit

If your air conditioner is installed and plugged into a proper re cep ta cle,
it is ready to go. The fi rst time the unit is started, the compressor will
delay for three minutes. See Automatic Component Protection on the
following page.
1
Touch the Power button once. The unit will automatically be in
Cool mode with the temperature set at 75 ° F (24 ° C) and the fan
speed at F1, the sleep setting.

To set mode of operation

When you fi rst turn the unit on, it will be in the Cool mode (light on)
with constant fan.
4
Figure 1
72
PM
3 4
Fan
Speed
9
Timer
On/Off
920-007-12
Model
WS08, WS10, WS14
WS10, WS13, WS16
Power
Cool
Money Saver ®
Mode
Fan Only
Clock
Set
Start Time
Hour
Stop Time
Temp/Hour
2
Touch the Mode button once to activate the MoneySaver
(light on).
MoneySaver
com pres sor so that the fan does not run all the time. This saves
energy and improves de hu mid i fi ca tion. MoneySaver
run to test the temperature if the off cycle is too long. Or you
may prefer con stant fan for more air move ment. (To return to
constant fan, touch the Mode button two more times).
In order to run the fan by itself, do the following:
3
Continuing from MoneySaver
button once to activate the Fan Only feature (light on).
The Fan Only setting will circulate air in the room without the
compressor coming on.
Circuit Rating, Breaker
Plug Type
or Time Delay Fuse
NEMA No. 5-15P
NEMA No. 6-15P
Figure 2
1
6
7
5
is a feature that cycles the fan with the
®
mode (light on), touch the Mode
®
125V-15 AMP
250V-15 AMP
®
will also
®