Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
_MSP702_MSP2524.book Seite 51 Freitag, 5. September 2008 3:36 15
SinePower
11.1
Set energy saving mode (Standby)
In energy saving mode, the inverter does not release any voltage, thereby
preserving the battery. If a connected appliance requires power which is
more than the pre-set power value, the inverter reverts to normal operation.
You can switch to energy-saving mode using the DIP switches S1, S2 and
S3 (fig. 3 1, page 4) and set the power value.
The switch positions for your inverter can be found in the following table:
Energy-saving mode up to
MSP 702
MSP 704
Off
15 W
25 W
40 W
50 W
65 W
75 W
85 W
11.2
Switch between 50 Hz and 60 Hz.
The output voltage can be switched between 50 Hz and 60 Hz with the DIP
switch S4 (fig. 3 1, page 4).
Warning!
e
Only adjust the S4 DIP switch when the respective frequency for
the output voltage should be used.
Set the S4 DIP switch (fig. 3 1, page 4) according to the following table:
Output voltage frequency
MSP 1012
MSP 2012
MSP 1024
MSP 2024
MSP 1512
MSP 2512
MSP 1524
MSP 2524
Off
20 W
40 W
55 W
75 W
95 W
115 W
135 W
50 Hz
60 Hz
DIP switch
S1
Off
Off
40 W
On
80 W
Off
125 W
On
170 W
Off
210 W
On
245 W
Off
280 W
On
S4 DIP switch
Off
On
Using the inverter
S2
S3
Off
Off
Off
Off
On
Off
On
Off
Off
On
Off
On
On
On
On
On
51
Publicité
Chapitres
Table des Matières
