Waeco SinePower MSP 702 Notice D'emploi page 24

_MSP702_MSP2524.book Seite 48 Freitag, 5. September 2008 3:36 15
Connecting the inverter
10.4 Connect the 230V output cables
Caution – danger of electrocution!
e
Before connecting the 230V
is switched off at the main switch.
➤ Connect the 230 V
page 3) to the 230V
10.5 Connect multiple appliances
The device is equipped at delivery with galvanic isolation. For the safe oper-
ation of multiple appliances, it is essential that a circuit breaker (residual cur-
rent circuit breaker) is built into the socket distribution circuit, see sample
circuit diagram in fig. 0, page 8.
Sample circuit diagram legend:
No. in
fig. 0, Explanation
page 8
1 230 V
2 additional devices, e.g. battery charger, refrigerator
3 DC power source (battery)
4 Inverter
5 Set grounding bridge (At delivery: not set, shown by dotted line)
6 Circuit breaker (residual current circuit breaker)
7 Socket distribution circuit for appliances
Caution – danger of electrocution!
e
If you wish to connect more than one appliance to the inverter and
install a socket distribution circuit, you must arrange a circuit break-
er (residual current circuit breaker) and set a grounding bridge in
the inverter.
➤ Install a residual current circuit breaker in the socket distribution circuit.
48
connection cable with safety coupling (fig. 1 4,
AC
output jack (fig. 3 4, page 4).
AC
power source
AC
output cable make sure the inverter
AC
SinePower