Waeco SinePower MSP 702 Notice D'emploi page 20

_MSP702_MSP2524.book Seite 44 Freitag, 5. September 2008 3:36 15
Fastening the inverter
Caution
a
Before drilling any holes, ensure that no electrical cables or other
parts of the vehicle can be damaged by drilling, sawing and filing.
Fastening the inverter horizontally
➤ Clip two holders on the left bar and two on the lower right bar (fig. 4,
page 5).
You can move the holders as required.
➤ Fasten the inverter by screwing one screw through each hole in the hold-
ers.
➤ Lay the cable socket (fig. 5 1, page 5) with the clip over the edge on the
back side of the inverter (fig. 5 2, page 5).
➤ Screw the cable socket on with one screw in each of the four holes.
Fastening the inverter vertically
➤ Clip two holders on the left bar and two on the lower right bar (fig. 4,
page 5).
You can move the holders as required.
➤ Screw the cable socket (fig. 6 1, page 6) on to the wall with one screw
in each of the four holes.
➤ Slide the inverter (fig. 6 2, page 6) onto the cable socket, so that the
edge on the back of the inverter is pinched between the wall and the clip
on the cable socket.
➤ Fasten the inverter by screwing one screw through each hole in the hold-
er.
44
SinePower