Ducane Affinity 3100 Guide De L'utilisateur page 29

NORMAL OPERATION
matCh liGhtinG Your Grill main burners
m danGer: failure to open the lid while igniting the
barbecue's burners, or not waiting five minutes to allow the
gas to clear if the barbecue does not light, may result in an
explosive flare-up which can cause serious bodily injury or
death.
A) Open the lid (1) and make sure that all burners are in the "OFF" position (2).
B) Turn the cylinder on by slowly turning the cylinder valve counterclockwise (3).
m warninG: the burner control knobs must be in the off
position before turning on the LP cylinder valve (3). If
they are not in the off position, when you turn on the lp
cylinder valve, the "excess gas flow control" feature will
activate, limiting the flow of gas from the lp cylinder. if this
should occur, turn off the lp cylinder valve and burner
control knobs. start over.
m danGer: when the "excess gas flow control" feature
is activated, a small amount of gas is still flowing to the
burners. after turning off the lp cylinder valve and burner
control knobs, wait at least five minutes for the gas to clear
before attempting to light the grill. failure to do so may
result in an explosive flare-up, which can cause serious
bodily injury or death.
C) Ignite the burners individually from left to right. Begin with the burner on the left (4).
Put match in the match holder and strike match. Insert match holder with lit match
(5) down through cooking grates, past the heat distribution plates and adjacent
to the left burner. Push control knob in and turn it to HIGH to ignite the left burner.
Check that the left burner is lit by looking through the cooking grates. You should
see a flame (6).
m warninG: do not lean over the open barbecue.
D1) (MODEL 3100 ONLY)
Ignite center burner (7) by putting match in the match holder and striking match.
Then, insert match holder with lit match down through cooking grates, past the heat
distribution plates and adjacent to the center burner. Push control knob in and turn
it to HIGH to ignite the center burner. Check that the center burner is lit by looking
through the cooking grates.
or
D2) (MODEL 4100/4200)
a) Ignite center-left burner (8) by putting match in the match holder and striking
match. Then, insert match holder with lit match down through cooking grates,
past the heat distribution plates and adjacent to the center-left burner. Push
control knob in and turn it to HIGH to ignite the center-left burner. Check that the
center-left burner is lit by looking through the cooking grates.
b) Next, ignite center-right burner (9) by putting match in the match holder and
striking match. Then, insert match holder with lit match down through cooking
grates, past the heat distribution plates and adjacent to the center-right burner.
Push control knob in and turn it to HIGH to ignite the center-right burner. Check
that the center-right burner is lit by looking through the cooking grates.
E) Ignite right burner (10) by putting match in the match holder and striking match.
Then, insert match holder with lit match down through cooking grates, past the
heat distribution plates and adjacent to the right burner. Push control knob in and
turn it to HIGH to ignite the right burner. Check that the right burner is lit by looking
through the cooking grates.
m warninG: if any burner fails to ignite during lighting, within
five seconds, stop, turn the burner control knob to off and
wait five minutes to allow the gas to clear before you try
again or light with a match.
- OFF -
ARRÊTÉ APAGADO
2
HIGH
LOW
MED
MAIN BURNER
5
4
7
3100
5
4
8
4100/4200
5
1
6
2
10
1
6
2
9
10
3
3
6
29