Main Burner Ignition - Ducane Affinity 3100 Guide De L'utilisateur

NORMAL OPERATION

main burner iGnition

Summary lighting instructions are inside the cabinet door.
m danGer: failure to open the lid while igniting the
barbecue's burners, or not waiting five minutes to allow the
gas to clear if the barbecue does not light, may result in an
explosive flare-up which can cause serious bodily injury or
death.
A) Open the lid (1) and make sure that all burners are in the OFF position (2).
B) Turn the cylinder on by slowly turning the cylinder valve counterclockwise (3).
m warninG: the burner control knobs must be in the off
position before turning on the LP cylinder valve (3). If
they are not in the off position, when you turn on the lp
cylinder valve, the "excess gas flow control" feature will
activate, limiting the flow of gas from the lp cylinder. if this
should occur, turn off the lp cylinder valve and burner
control knobs. start over.
m danGer: when the "excess gas flow control" feature
is activated, a small amount of gas is still flowing to the
burners. after turning off the lp cylinder valve and burner
control knobs, wait at least five minutes for the gas to clear
before attempting to light the grill. failure to do so may
result in an explosive flare-up, which can cause serious
bodily injury or death.
electronic ignition system
Each control knob operates an individual burner, and each burner ignites with an
electronic igniter. The electronic ignition system ignites each burner individually with a
spark from the igniter electrode inside the ignition box. You generate the energy for the
spark by pushing the electronic ignition button. You will hear it clicking.
C) Ignite the burners individually from left to right. Begin with the burner on the left (4);
push control knob in and turn it to HIGH. Push and hold in the electronic ignition
button (5). You will hear it clicking. Check that the left burner is lit by looking through
the cooking grates. You should see a flame (6).
m warninG: do not lean over the open barbecue.
D1) (MODEL 3100 ONLY)
Ignite center burner (7) by pushing control knob in and turning it to HIGH. Then,
push and hold in the electronic ignition button (5). You will hear it clicking. Check that
the center burner is lit by looking through the cooking grates.
or
D2) (MODEL 4100/4200)
a) Ignite center-left burner (8) by pushing control knob in and turning it to HIGH.
Then, push and hold in the electronic ignition button (5). You will hear it clicking.
Check that the center-left burner is lit by looking through the cooking grates.
b) Next, ignite center-right burner (9) by pushing control knob in and turning it to
HIGH. Then, push and hold in the electronic ignition button (5). You will hear it
clicking. Check that the center-right burner is lit by looking through the cooking
grates.
E) Ignite right burner (10) by pushing control knob in and turning it to HIGH. Push and
hold in the electronic ignition button (5). You will hear it clicking. Confirm that the
right burner is lit by looking through the cooking grates.
m warninG: each burner must be ignited individually by
pushing the electronic ignition button. failure to do so may
cause a flare-up of gas which can cause serious bodily
injury and damage to property.
m warninG: if any burner fails to ignite during lighting, within
five seconds, stop, turn the burner control knob to off and
wait five minutes to allow the gas to clear before you try
again or light with a match.
28
- OFF -
ARRÊTÉ APAGADO
2
HIGH
LOW
MED
MAIN BURNER
6
5
4
7
3100
6
5
4
8
9
4100/4200
5
1
2
10
3
1
2
10
3
www.ducane.com