Berner BHFB 05/12V EVO Instructions D'utilisation page 10

(EN)
• Do not operate charger with damaged cord or plug – replace the
cord or plug immediately.
• Do not operate charger if it receives a sharp blow, been dropped, or
otherwise damaged in any way; take it to a qualified serviceman.
• Do not disassemble charger; take it to a qualified serviceman when
service or repair is required. Incorrect reassembly may result in a risk
of electric shock or fire
• To prevent injury during cleaning or maintenance, disconnect all
batteries and move them to clear access to the unit. Unplug BHFB
05/12V EVO Chargers from the wall outlet. Use a slightly dampened
cloth to clean the housing and lead sets. Do not use solvents or
soaps.
• Place the power cords in a location where they will not be stepped
on, tripped over, or subjected to stress or abuse of any kind.
• For fuse replacement, contact distributors for replacement. Any
tampering or in correct assembly may result in fire or electric shock
and voids the warranty.
• Never attempt to charge a frozen battery. Allow the battery to
return to room tem perature before connection. Suggested operation
range 0 (32) to 50 (104) inambient temperature.
• Never use BHFB 05/12V EVO Chargers in or on any boat or water-
craft. You must remove the battery from the boat or watercraft and
charge the battery at the properly installed battery from the boat or
watercraft and charge the battery at the properly installed location of
BHFB 05/12V EVO Chargers.
• Do not install BHFB 05/12V EVO Charger where it will be exposed
to moisture or inclement weather, or around combustibles like trash,
flammable liquids and vapors. Warning – Risk of explosive gases.
• Working in the vicinity of lead acid battery is dangerous. Batteries
generate explosive gases during normal battery operation. For this
reason, it is of utmost importance that each time befor using DHC
chargers, you read manual and follow the instructions exactly.
• To reduce risk of battery explosion, follow these instructions and
those published by the battery manufacturer and manufacturer
of any equipment you intend to use in the vicinity of the battery.
Observe cautionary markings on these items.