LG G Pad III 8.0 FHD Mode D'emploi page 18

Do not attempt to repair or modify the device yourself. Your device
is equipped with an internal rechargeable battery which should be
replaced only by LG or an authorized LG repair centre. You should
never attempt to open or disassemble this device yourself and doing
so may cause damage that will void your warranty.
Consumer Information on SAR (Specific Absorption
Rate)
This Model Device Meets the Government's Requirements for
Exposure to Radio Waves.
Your wireless device is a radio transmitter and receiver. It is designed
and manufactured not to exceed the emission limits for exposure
to radiofrequency (RF) energy set by the Federal Communications
Commission (FCC) of the U.S. Government. These limits are part of
comprehensive guidelines and establish permitted levels of RF energy
for the general population. The guidelines are based on standards that
were developed by independent scientific organizations through periodic
and thorough evaluation of scientific studies. The standards include a
substantial safety margin designed to assure the safety of all persons,
regardless of age and health.
The exposure standard for wireless mobile device employs a unit of
measurement known as the Specific Absorption Rate, or SAR. The SAR
limit set by the FCC is 1.6 W/kg. * Tests for SAR are conducted using
standard operating positions specified by the FCC with the device
transmitting at its highest certified power level in all tested frequency
bands.
Although SAR is determined at the highest certified power level, the
actual SAR level of the device while operating can be well below the
maximum value. Because the device is designed to operate at multiple
power levels to use only the power required to reach the network, in
general, the closer you are to a wireless base station antenna, the lower
the power output.
Before a device model is available for sale to the public, it must be tested
and certified by the FCC that it does not exceed the limit established by
Safety Guidelines 17