Initial Preparations - Bosch EXTEGRA IP 9000 FX Manuel D'installation

en | Planning
16
Figure 3.3: Side view
3.2

Initial Preparations

The camera transmits zoom control commands and images over a TCP/IP network. It also
allows users to configure the camera display settings, camera operating settings, and to
configure the network parameters.
The camera incorporates a network video server in the IP module. The primary function of the
server is to encode video and control data for transmission over a TCP/IP network. With this
H.264 encoding, it is ideally suited for IP communication and for remote access to video
management systems. The use of existing networks means that integration with CCTV systems
or local networks can be achieved quickly and easily. Video images from a single camera can
be simultaneously received on several receivers.
–
–
Caution!
It is recommended that the installer wear an ESD strap or discharge any static electricity to
!
ground before handling any electronic components.
Notice!
To avoid excessive moisture saturation inside the housing, limit the amount of time that the
unit housing is open. Bosch recommends that the unit housing be open for no more than five
(5) minutes.
2016.02 | 1.2 | F.01U.319.357
471
18.54
100
3.94
Determine the operating voltage at the installation site. The unit can receive an input
voltage range of 24 VAC ± 10%/HPoE without damage.
All units have been tested prior to shipment. It is advisable to check the unit's operation
before installation.
Installation Manual / Guide d'installation
90°
381
15.01
EXTEGRA IP 9000 FX
114
4.50
208
8.18
Bosch Security Systems