Mounting; Mounting The Unit - Bosch EXTEGRA IP 9000 FX Manuel D'installation

EXTEGRA IP 9000 FX
7

Mounting

7.1

Mounting the Unit

Follow all local codes with respect to the wiring and installation of explosion protected
housings.
Caution!
Ensure the selected location is protected from falling objects, accidental contact with moving
!
objects, and unintentional interference from personnel. Follow all applicable building codes.
The following installation guidelines must be followed:
–
–
–
The unit can be mounted to a compatible Bosch bracket with M6 bolts, or to any purpose-built
bracket using M6 or 1/4 in.–20 bolts. Note: Ensure that a fabricated bracket is capable of
supporting at least three times the weight of the system.
The stainless steel mount adapter (EXS-ADPT) that allows installers to mount an EXTEGRA IP
9000/EX65 device onto one of a variety of mounting brackets originally designed for the MIC
series of cameras. Installers secure the adapter to a MIC Wall Mount Bracket (MIC-WMB), and
then secure the mounting cradle of the device to the mount adapter. The MIC-WMB can be
mounted to any of the following MIC mounting brackets:
–MIC Spreader Plate (MIC-SPR) for installation on a wall
–MIC Corner Mount Bracket (MIC-CMB) for installation in a corner
–MIC Pole Mount Bracket (MIC-PMB) for installation on the side of a CCTV pole.
Refer to the datasheet "MIC Mounting Brackets and Other Accessories" for details about these
mounts.
To install the camera onto a MIC mounting bracket, follow these steps:
1.
2.
3.
4.
5.
Bosch Security Systems
Locate the unit such that it cannot be easily interfered with, either intentionally or
accidentally.
Select mounting hardware and a mounting surface capable of supporting the combined
weight of the equipment under all expected conditions of vibration and temperature.
Secure all cabling.
Install the chosen MIC mounting bracket.
Install the MIC-WMB.
Mount the EXS-ADPT to the MIC-WMB using the four (4) supplied screws.
Align the three (3) holes in the mounting cradle to any three (3) holes (in a line) in the
EXS-ADPT.
Install the center bolt first, and then rotate the camera in the desired direction for
surveillance. When the camera is in the desired position, install the other two (2) bolts.
Proceed to step 6 below.
Installation Manual / Guide d'installation
Mounting | en
27
2016.02 | 1.2 | F.01U.319.357