Connections; Power Cable Requirements; Wire Distance Guide; Ethernet Cable Requirements - Bosch EXTEGRA IP 9000 FX Manuel D'installation

en | Connections
22
6

Connections

6.1

Power Cable Requirements

Warning!
!
Before proceeding, disconnect the power from the power supply cable. Ensure that the
voltage of the unit matches the voltage and type of the power supply being used.
Connect power from a 24 VAC class 2 power supply. Use AWG 16 to 22 stranded wire or AWG
16 to 26 solid wire; cut back 5 mm (0.2 in.) of insulation.
Cable size
Cable shape
Conductors
Environmental
Warning!
Bosch's version of High PoE:
!
If supplying power to the camera by HPoE or a midspan device, you must install additional
surge protection.
The table below identifies the power devices that can be connected simultaneously to the
camera.
60 W midspan (NPD-6001A)
95 W midspan (NPD-9501A)
VIDEOJET connect (VJC-7000-90)
6.1.1

Wire Distance Guide

This table lists the maximum wire distances for 16 and 18 AWG wires for 24 VAC power.
With OFC Kit
Without OFC Kit
6.2

Ethernet Cable Requirements

Cable Type
Maximum Distance 100 m (330 ft)
Terminal
Connector
2016.02 | 1.2 | F.01U.319.357
Stranded wire: AWG 16 to 22
Solid wire: AWG 16 to 26
Round
2-conductor version
Outdoor rated
If power is supplied from:
16 AWG
(1.5 mm)
40 m (131 ft)
42 m (136 ft)
Cat5e/Cat6e Ethernet (directly to the camera, or to a network switch
between the camera and the network)
RJ45, Male
Installation Manual / Guide d'installation
Camera can receive power simultaneously from:
24 VAC PSU
(VG4-A-PSU1, VG4-A-PSU2)
18 AWG
(1.0 mm)
25 m (83 ft)
26 m (86 ft)
EXTEGRA IP 9000 FX
Bosch Security Systems