Bosch 500 Série Mode D'emploi page 9

Four encastrable
Masquer les pouces Voir aussi pour 500 Série:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Combination Oven Pre-Assembly
2. The screw in position A (nearest the inside edge, near
control panel) must be moved to allow the universal
bracket to be postioned there. Remove the inside
screw (A) from the left support bracket and reinsert it
into the third hole (B) from the inside edge of the
support bracket. Repeat for the right support bracket.
3. Reattach the slide assemblies using the holes near the
inside edge of the support bracket. Align the slide
assembly parallel to the edge of the bracket and insert
the first screw in hole (C). Insert all three screws for
each slide assembly. Tighten the screws securely, but
do not overtighten.
Note: When the correct holes are used, the front of the
slide assembly will extend just past the edge of the horizon-
tal support bar. The slide assembly will be about 1/8" (3
mm) from the inside edge of the support bracket.
4. Install the two universal connector brackets to the slide
assemblies using the screws provided. Tighten screws
securely, but do not overtighten.
Note: The universal connector brackets are interchange-
able for the left and right sides of the oven. Be sure the
taller vertical edge of the bracket is positioned to the out-
side of the oven.
5. Install the decorative trim.
Position the decorative trim
piece so the flanges with
the holes in them face
away from the oven door.
Align the inner flanges with
the inside of the universal
brackets. Fasten with one
screw each into the end
hole of the universal
bracket. Tighten screws
securely, but do not
overtighten.
6. Place the steam oven unit on top of the universal
connector brackets and fasten in place using two
screws per side. Tighten the screws securely, but do
not overtighten.
Note: The existing screws in the steam oven base help
with alignment. When lowering the steam oven into
place on the universal connector bracket, allow these
screw heads to slide into the slots as shown in the
illustration below. The screw nearest the front of the
steam oven slides into the base of the slope at the front
of the bracket.
English 6

Publicité

Table des Matières
loading

Table des Matières