Napoleon BHD4N Série Instructions D'installation Et D'opération page 39

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

4. Place log #3 onto the pin located in log #2 and let it rest on log #2, as
shown in Figure 3 and in the left side view below. Place another pin
into log #2, as shown in Figure 3.
5. Place log #4 onto the pin located in log #2 and let it rest on log #2, as
shown in Figure 4 and in the left side view. Place one pin into the left
side hearth pad, as shown in Figure 4.
6. Place log #5 onto the pin located in the left side hearth pad and let it
rest on the burner, as shown in Figure 5.
NOTE: Ensure log #5 does not cover any burner ports.
7. Place log #6 onto the pin located on the right side corner of the
burner, then place one pin into middle of the log #6 and log #5, as
shown in Figure 6.
NOTE: Ensure log #6 does not cover any burner ports.
8. Place log #7 onto the pin located in log #6 and onto the pin in log #5,
as shown in Figure 7.
9. Place log #8 on the hearth pad and let it rest against the notch in the
side of log #7, as shown in Figure 8. HINT: The best view of log #8
is shown in the left side view below.
10. Place log #9 onto the pin located in log #6 and let it rest on the right
side corner hearth pad and then place one pin into log #7, as shown
in Figure 9.
11. Place log #10 onto the pin located in log #7 and let it rest in the
middle of the right side hearth pad, as shown in Figure 10. Place one
pin into log #1, as shown in Figure 10.
12. Place log #11 onto the pin located in log #1 and let it rest on the right
end hearth pad, as shown in Figure 11.
13. Place charcoal lump #12 onto the two pins located in the center of
the burner, as shown in Figure 12.
14. Install the glowing embers, see "GLOWING EMBERS" section.
15. Sprinkle the charcoal embers around the log support, see
"CHARCOAL EMBERS" section. (Use illustration below as reference).
16. Place the charcoal lumps on top of the charcoal embers, see
"CHARCOAL LUMPS" section. (Use illustration below as reference).
NOTE: Do not cover the pilot or burner ports with media or embers.
Do not overfill.
1
11
6
10
3
4
12
7
2
6
RIGHT SIDE VIEW
10
7
8
5
3
2
LEFT SIDE VIEW
9
11
1
4
39
PIN
Fig. 4
Fig. 5
PINS
Fig. 6
Fig. 7
Fig. 8
PIN
PIN
Fig. 9
Fig. 10
PIN
Fig. 11
Fig. 12
W415-1285 / F / 12.21.16
EN

Publicité

Chapitres

Table des Matières
loading

Table des Matières