Hoover FREESPACE Nanopack Instructions D'utilisation page 8

Freespace_bag_nanopack_V3.qxp
To remove the Purefilt exhaust filter:
1. Unlatch and remove exhaust filter cover (P23)
2. Remove the washable exhaust filter.
Cleaning the permanent dust bag (depending on model) - To maintain optimum
performance we recommend that you wash the permanent bag under handwarm
water after every 5 full bags. Remove excess water with a dry cloth and leave to dry
fully before replacing.
Cleaning the washable filters - To maintain optimum performance please tap and, if
necessary, wash the pre-motor and exhaust filters after each bag change using
handwarm water. Remove excess water with a dry cloth and leave to dry fully before
replacing.
Important: Do not use hot water or detergents to wash the filters or permanent dust
bag. In the unlikely event of the filters or dust bag becoming damaged, fit a genuine
Hoover replacement. Do not try and use the product without the bag or filters fitted.
Removing a blockage from the system - If the bag check indicator is illuminated:
" Check if the bag is full. If so refer to 'Replacing the dust bag'.
" If the bag is not full but the indicator is illuminated:
1. Do the filters need cleaning? If so refer to 'Cleaning the washable filters'
2. Check if there is any other blockage in the system - Use a rod or pole to remove
any blockage from the extension tube or flexible hose.
Warning –The bag check indicator will remain illuminated if the cleaner is used when
the bag is full, if there is a blockage or if the filters are dirty. If used for a period of
over ten minutes with the bag check indicator illuminated, an electronic cut out will
switch the cleaner off to prevent any risk of overheating. If this should happen, switch
the cleaner off, unplug and correct the fault (see ' Removing a Blockage From the
System'). The cut out will automatically reset upon switching the cleaner back on.
USER CHECKLIST:
Should you have a problem with the product, complete this simple user checklist
before calling your local Hoove
• Is there a working electricity supply to the cleaner? Please check with another
electrical appliance.
• Is the dust bag over-filled? Please refer to 'Cleaner Maintenance'.
• Is the filter blocked? Please refer to 'Cleaner Maintenance'.
• Is the hose or nozzle blocked? Please refer to 'Removing a Blockage from the
System'.
13/03/2007 12:38 Page 4
4
GB