Removing The Unit - Kenwood KRC-694 Mode D'emploi

Installation
Removing the hard rubber frame
1
Engage the catch pins on the removal tool and remove the
two locks on the upper level.
Upper the frame and pull it forward as shown in the figure.
Accessory2
Removal tool
2
When the upper level is removed, remove the lower two
locations.
The frame can be removed from the bottom side in the same manner.
1
2
3
Lock
Catch
4
5
— 30 — — 30 —

Removing the Unit

Refer to the section <Removing the hard rubber frame> and
then remove the hard rubber frame.
Remove the screw (M4×8) on the back panel.
Insert the two removal tools deeply into the slots on each
side, as shown.
Screw (M4X8)
(commercially
available)
Lower the removal tool
toward the bottom, and
pull out the unit halfway
while pressing towards the
inside.
Be careful to avoid injury from the catch pins on the removal tool.
Pull the unit all the way out
with your hands, being
careful not to drop it.
Accessory2 Removal tool